您所在的位置:首页 >产品中心 >防水背胶系列 防水背胶系列
  • 1
  • 防水背胶
名称:防水背胶
详细介绍

科特固石宝防水背胶,是一种由水生高分子聚合物和多种无机硅酸盐凝胶材料配制而成的双组份产品,具有很好的防水性能、干燥收缩小、有韧性与水泥基材料粘结力强等特点,避免了石材湿贴施工后易起壳、脱落和表面产生白华的缺陷。

一、用途:

1、用于粘贴大理石的增强背网,背网层不需铲除,提高粘结强度和防水性能。

2、用于湿贴施工的石材、大规格墙地砖,提高粘贴面粘结强度和防水性能。

二、特点:

1、石材背面防护材料,硬化收缩小且有韧性;不污染环境对人体无害,环保。

2、持久粘贴,不脱层起壳。

3、与水泥砂浆粘接良好,施工时无需铲,减少破损。

4、防水抗渗,有效防止水斑,白华。

三、使用说明:

1、1、材料拌制:将液体与粉来体以1:3的重量比放入搅拌桶内,用电动搅拌机搅拌均匀,制成糊状混合物,静置5-10min后涂刷。拌好的浆料控制在2h内用完。

2、2、粘贴背网:将适量的浆料倒于石板底部粘结面,用批板将浆料均匀批涂于整个粘结面,厚度约0.3-0.5mm;将预先裁切好的网格布压平并再次薄涂一层浆料,厚度约0.3-0.5mm;自然晾干,也可烘干至表干,过1-2天背网层实干后可进行打磨、切割。

四、包装运输:

1、本产品为非易燃品,非危险品,能运输,避免雨淋和撞跌,破坏包装。

2、本产品应贮存在干燥阴凉的仓库内,忌长期暴露在空气中。

3、本产品保存期为6个月。

4、液体组份用塑料桶包装:小桶:20kg/桶  大桶:200kg/桶;粉体组份用复合纸袋包装:20kg/袋。

五、注意事项:

1、严格按规定的配比,搅拌均匀;

2、施工时不得添加其它材料和外加剂;

3、每次施工完毕,用清水清洗工具及机械设备。

Cote solid Shibao waterproof adhesive, a polymer composed of water and a variety of raw inorganic silicate gel material prepared from the two-component products, with very good water resistance, drying shrinkage, toughness strong bond with the cement-based materials, etc., to avoid the easy to play after the construction shell stone wet paste, Bai Hua loss and surface defects.

First, use:

1, for pasting marble enhanced back net, back mesh layer without eradication, improve bond strength and water resistance.

2, for the construction of the stone wet paste, large size tiles, improve bond strength and waterproof adhesive surface properties.

Second, characteristics:

1, the back of the stone protective materials, curing shrinkage and toughness; do not pollute the environment on humans, safety and environmental protection.

2, lasting paste, no delamination from the shell.

3, with good adhesion to cement mortar, the construction without shovel, reducing breakage.

4, water impermeability, prevent water spots, Bai Hua.

Third, use:

1, Material mixing:

The liquid and powder to form a 1: 3 ratio of weight into the mixing bucket, stirring with an electric mixer evenly to form a paste mixture, after standing 5-10min brushing. Marinated stock control used within 2h.

2, paste the back net:

An appropriate amount of slurry is poured in stone at the bottom of the adhesive surface, the slurry was uniformly with approved board approved the adhesive applied to the entire surface, a thickness of about 0.3 -0 5mm;. The precut good mesh flatten and thin again coat of paste, a thickness of about 0.3-0.5mm; dry naturally, can also be dried to form dry, too l-2 天 back net after layer of hard work can be polished, cut.

Fourth, packaging and transportation:

1, the product is non-flammable, non-hazardous, safe transport, to avoid the rain and hit down, destroying the packaging.

2. The product should be stored in a cool dry warehouse, avoid long-term exposure to air.

3, the product shelf life of six months.

4, the liquid component with a plastic pail: kegs: 20kg / barrel vat: 200kg / barrel; powder components with composite bag: 20kg / bag.

V. Note:

1, in strict accordance with the provisions of proportion, stir;

2, can not add other materials and additives construction;

3, each construction is completed, with water cleaning tools and equipment.